How do I apply Dip?Updated 21 hours ago

Step 1: Base Powder

• Swirl/fluff the Base Powder before you begin.
• Work one nail at a time.
• Apply a thin coat of Dip Powder Base Coat to the upper 3/4 of the nail through the tip.
• Leave a small gap at the sides of the nail and avoid getting Base Coat on skin.
• Dip immediately into Dip Base Powder and tap off excess.
• If you see shiny or bare spots, re-dip immediately.
• Clean around the cuticle with the Dip Clean-up Tool and brush away excess with the Dust Brush.
• Repeat with the remaining nails, one at a time.
• Keep the powder fluffy throughout application — swirl/fluff approximately every 1–2 nails.

Step 2: Color

• Swirl/fluff the Color Powder before applying Base Coat.
• Apply Dip Powder Base Coat over the entire nail, avoiding the skin and cuticle and leaving a thin border around the sides.
• Dip immediately into Dip Color Powder and tap off excess.
• Clean around the cuticle and sidewalls right away.
• Repeat with the remaining nails, continuing to swirl/fluff the Color Powder every 1–2 nails.
• Brush away excess powder, then repeat with Base Coat plus a second coat of Dip Color Powder.

Step 3: Set + Shape

• Apply Dip Powder Activator using no more than 1–2 strokes.
• Let dry for 2 minutes.
• Apply an even layer of Dip Powder Base Coat over the entire nail and let dry for 2 minutes.
• Buff in gentle circular motions until the surface is matte, smooth, and even, including the cuticle line and sidewalls.
• Start with the Shape/coarser side of the buffer and finish with the Smooth side.
• Spend at least 30 seconds with each side of the buffer.
• If the sidewalls need refinement, file gently in one direction rather than sawing back and forth.

Step 4: Seal

• Brush away buffing dust with the Dust Brush.
• Apply another even coat of Dip Powder Activator using no more than 1–2 strokes.
• Avoid repeatedly brushing over the same area.
• Let dry for 2 minutes.

Step 5: Shine

• Apply an even coat of Dip Powder Top Coat over the entire nail.
• Let dry for 5 minutes.
• The Top Coat should feel hard and dry, not tacky.
• Do not wash your hands for at least 10 minutes after finishing.
• Wait 1 hour before applying hydration products.